SERVICES PROVIDED FOR MEASUREMENT MICROSCOPE SYSTEMS (TOOLSCOPES)
Per ACC Proprietary Procedure # MP-TOOLCAL and # NPWI-OPTCLN
·
Perform
full evaluation of system including:
Þ
Evaluation
of microscope optical system and components
Þ
Evaluation
of DRO system.
Þ
Evaluation
of photo/video attachments
Þ
Evaluation
of encoders (lip seals, hardware tightness, etc.)
·
Full
cleaning of exterior surfaces.
· Clean all optical elements including eyepieces, beam split mirror, objectives and final magnification lens.
·
Check
stage operation.
Þ
Clean and
lubricate all applicable areas using synthetic lube.
· Check operation of objective turret - make minor adjustments if necessary and possible.
·
Check all
hardware for looseness - tighten as needed.
·
Clean and
adjust illumination for maximum output and best image clarity.
·
Clean,
center, focus and adjust all photo and/or video attachments.
·
Perform
minor mechanical adjustments to optimize system.
·
Calibrate
all applicable axes - X,Y,Z filar, Field of View measurement.
·
Re-configure
DRO with LEC corrections (when possible).
·
Furnish
Certificate of Accuracy with Before/After data.
·
If
necessary, furnish written report of any problems found.
Note any action needed to increase system productivity and accuracy.
Note estimated costs regarding needed actions (if available).
·
ACC glass
master stage micrometer calibrated traceable to NIST to .00001”
·
ACC steel
and ceramic master gage blocks calibrated traceable to NIST to .000002” (2 micro inches).
·
All
calibrations conform to ANSI/NCSL Z540-1 and meet ISO requirements.
ABSOLUTE CLARITY & CALIBRATION,
LLC
109 Main
Street v
Terryville, CT
06876
(860) 583-0502 v
(860) 314-1851 (fax)